WA3RNC Acrylic 40 Meter Transceiver

Out of stock
Acrylic 40 Meter Transceiver

40 Meter Transceiver Kit

  • Builds in just a few hours, not a whole weekend
  • No-Solder version available with board completely wired and tested
  • Tunes approximately 7.017 to 7.047 MHz (approximately 30 KHz)
  • Superhet design with sharp IF crystal filter (NOT direct conversion)
  • All toroidal transformers are pre-wound  for quick assembly
  • Output is adjustable from 0 to 5 watts or more with rear panel control
  • Receiver sensitivity 0.15 microvolts (MDS), image rejection -76dB
  • Sharp IF crystal filter (350 Hz @-6dB) for single signal reception
  • Front panel LED receive signal indicator for judging signal strength
  • 12 dB receiver attenuator switch with front panel LED indicator
  • Effective audio derived AGC to limit volume on strong signals  
  • Transmitter harmonics and spurs down better than -55dBc
  • Receiver current consumption <37 ma, transmitter 400-800 ma
  • PC board is supplied with 104 SMT parts machine installed
  • 16 additional alignment critical parts are factory installed
  • The board arrives tested and completely factory aligned for you
  • Builder installs 24 components, and the board is finished
  • ALL parts on the board are installed in the no-solder version
  • Acrylic orange “Edge Glow” chassis is preformed and machined
  • The panel control interconnection harnesses are wired and tested
  • Transceiver has excellent performance…This ain’t no “Pixie”!
  • Download standard assembly instructions
  • Download no-solder assembly instructions
Write Your Own Review
You're reviewing:WA3RNC Acrylic 40 Meter Transceiver
Copyright © 2017 WA3RNC