TR-25 CW Transceiver Kit (Retired)
$199.00
Out of stock
SKU
TR24CWTRANSCEIVERKIT
TR-25 is Retired and No Longer Available
A compact but powerful 2-band CW transceiver kit that uses no tiny pushbuttons, and without those seemingly endless and hard-to-remember back menus. There is a knob or a switch for every function!
TR-25 is Retired and No Longer Available
Here is a compact but powerful 2-band CW transceiver kit that uses no tiny pushbuttons, and without those seemingly endless and hard-to-remember back menus. There is a knob or a switch for every function!
DC Input Voltage Vs. Typical RF Output
DC In | 20 meters | 40 meters |
9.5V | 3.5W | 4.0W |
10V | 4.0W | 5.0W |
12V | 5.0W | 7.0W |
14V | 7.0W | 9.0W |
- Size 5 ½ X 3 ¼ X 1 ½ less protrusions, weight 10.6 Oz
- Full CW band coverage of 40 and 20 meters
- Optimized for operation from 3 series-connected 18650 Lithium cells
- RIT tunes + and – 5KHz
- Blue OLED display reads frequency to 10 Hz and RIT offset
- Built in Iambic keyer is adjustable 5 to 35 WPM with front panel control
- Separate jacks for straight key and paddles; Always ready for SKCC contacts
- Operates on 9.5 to 14 volts, < 110ma receive, about 1.1 Amp Xmitt at 10 volts
- Selectable tuning resolution steps of 10, 100, and 1000Hz
- Low battery indicator with internal adjustment 9.5 to 11.5 volts
- Front panel adjustable RF gain control
- Front panel TX power control; Adjustable from 0 to full output
- Rugged TO-220 FET RF amp has delivered 5 Watts key down for 5 minutes
- Signal quality blue LED, RIT warning orange LED, Low battery red LED
- More than enough audio to fill any room with an external speaker
- Excellent receiver sensitivity with MDS of -125dBm
- Very effective receive AGC prevents ear damage with strong signals
- Transmitter harmonics and spurs -52dB, meets FCC specs
- CW sidetone is the actual transmitter signal as heard by receiver
- Match the received signal tone to the sidetone for perfect zero beating
- Sharp IF filter; Better than 350 Hz at the -6dB point, plus 700 Hz audio filter
- Over 200 machine placed SMT parts, and about 55 user installed parts
- All critical circuits are factory pre-aligned and calibrated
- No endless “back menus”; There is a control or switch for every function
- Options include pre-wound toroid coils and complete factory assembly
Resources:
- TR-25 Pre-Assembly Information
- TR-25 Lower Board Assembly Procedure
- TR-25 Upper Board Assembly Procedure
- TR-25 Final Assembly
- TR-25 V020 Mod
- TR-25 Checks and Tests
- TR-25 Operating Instructions
- TR-25 Lower Board Schematic
- TR-25 Upper Board Schematic
TR-25 Reviews:
Write Your Own Review